Insert the lower section first

Insert the lower section of the holder, including the corresponding lower brackets, into the printer pocket first.

Finishing touch

Press the upper section of the holder into the printer pocket until it is fully seated.

Ensure the lower brackets are fully engaged in their final position before performing this step.

Description of the holder

The holding brackets at the top( near the triangular opening) have a different geometry than the brackets at the bottom. Because of this, the correct insertion sequence is critical. Incorrect insertion or fastening can cause the brackets to deform or break.

The required order is marked directly on the holder with the numbers“ 1” and“ 2”. Always follow this sequence when attaching the holder to the printer bracket.

Holder in the final position

Removing the holder out

Insert a finger into the opening near the top of the holder.

Apply slight downward pressure on the holder( toward the bottom side, as indicated by the card‐reader label in the image).

Pull the holder out of the printer, removing the upper section first, followed by the lower section, while maintaining pulling force through the finger inserted in the opening.